Canopies made of steel, galvanized and painted in any color RAL. Type of fixing to the wall and the thickness of the glass is selected depending on the dimensions of the roof, a place where the roof is to be approached installed and the type of supports. The standard version is IPE 120-140, and glass TVG 6.6.2 or 8.8.4.
The fastening system from the outside using steel sheets 16mm to wall. Fixing the canopies from the bottom fixing point ESKATT on tension. Main profile made of IPE160 structures supporting the roof. Additional built-in backlight ES-LED-LIGHT – 5 piece along with the motion sensor.
The main profiles made of IPE140, connectors ESKATT system, used glass TVG 6.6.2. In addition, the glass protrusions beyond the outline of the structure. Mounting plate ESKATT system. Fixing of the glass sheet from the bottom of the structure by means of screws.
Glass canopies with tension ES-GLASS-SPOOT
Glass canopies system made the round of tempered safety glass 2x5mm, 2x6mm, 2x6mm, 2x8mm, 2x10mm, 2x12mm, 3x4mm, 3x6mm, 3x8mm. Glass characteristics are chosen to frame size and the nature of the main profiles or tensions. The following table specifies the maximum length and width parameters pane of glass. Main roof profiles can be used round, square or supporting joists made of stainless steel as below.
Below are the elements of canopies ES-SPOOT production ESKATT. Glass canopies elements made of square.
ES-SPOOT-R-R
ES-SPOOT-R-GR
ES-SPOOT-R-GW
Glass canopies ES-SPOOT-2 "square"
Canopies made in the system tensions and square mounts. Other parameters as above.
Below are the elements of canopies ES-SPOOT production ESKATT. Glass canopies elements made of square.
